Kia Rio Manuals

Kia Rio: Fender Replacement - Exterior - Body (Interior and Exterior) - Kia Rio UB 2012-2026 Service ManualKia Rio: Fender Replacement


     
•
When removing and installing the fender, an assistant is necessary.
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the front bumper cover.
(Refer to the BD group – “Front bumper”)
2.
Remove the head lamps.
(Refer to the BE group – “Head Lamps”)
3.
Using a screwdriver or remover, remove the front pillar trim (A).
4.
Disconnect the tweeter speaker connector (A).
5.
Loosen the delta glass mounting nuts.
Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)


6.
Remove the delta glass (A).
7.
Loosen the wheel guard (A) mounting screws.
8.
After loosening the mounting screws, then remove the front bumper side mounting bracket (A).
9.
After loosening the mounting bolts, then remove the fender assembly (A).
10.
Installation is the reverse of removal.
Exterior
...

Hood Replacement
Hood Assembly Replacement    • When removing and installing the hood, an assistant is ...

See also:

Ignition Coil: Removal
1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connec ...

5Door Side Body B
Side outer panel notch Side outer panel notch Side outer panel notch ...

Troubleshooting
Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) is blown Check for short and replace fuse Speedometer faulty ...

Categories

Copyright www.kirmanual.com 2014-2026