Kia Rio: Thermostat: Installation - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Thermostat: Installation

1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)


3.
Fill with engine coolant.
4.
Start engine and check for leaks.
Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...

Thermostat: Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting ...

See also:

Overhead Console Lamp Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp lens (B). 3. After ...

Clutch & Brake
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C), a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake (UD/B), a 26 brake (26/B), and a 35R clutch ...

Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air tem ...

Copyright www.kirmanual.com 2014-2026