1. |
Apply tire soap or lubrication to the top and bottom tire beads.
|
2. |
To fit the bottom bead, position the valve at the 5 o’clock position
relative to the head on the tire changing machine.
|
3. |
Place the tire on the rim so the bottom bead touches the edge
of the rim after the valve (6 o’clock). Rotate the rim clockwise, and
push down on the tire at the 3 o’clock position to fit bottom bead.
|
4. |
After bottom bead is on tire, rotate the rim until the valve is
at the 5 o’clock position relative to the head on the tire changing
machine. Push down on the tire at the 3 o’clock position and rotate
the rim clockwise to fit the top bead.
|
5. |
Inflate the tire until both beads seat.
|
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
3.
Check th ...
Starter: Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly. (Refer to EM group)
3.
...
Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...