Kia Rio: TPMS Receiver Operation
|
1. |
General Function
| A. |
Auto-learn takes place only once per Ignition cycle.
|
| B. |
On successful completion, 4 road wheel sensor ID's are
latched into memory for monitoring.
|
| C. |
Until Auto-learn completes, previously learned sensors
are monitored for under inflation / leak warnings.
|
|
|
2. |
General Conditions to Learn New Sensors:
| A. |
Receiver must determine that it is confident that sensor
is not temporary:
|
| 2) |
Uses confidence reduction of previously learned
sensors.
|
|
| B. |
Typical time at driving continuously over 12.4 mph(20
kph) to learn a new sensor is up to 20 minutes.
|
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
| A. |
It takes less than 20 minutes at 12.4 ~ 18.6 mph(20 ~
30kph).
|
| B. |
Confidence reduction is dependent on time which vehicle
is driven at speed greater than or equal to 12.4 mph(20 kph).
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
TJ Joint Replacement
•
Special grease must be applied to the driveshaft joint.
Do not substitute with anoth ...
Adjustment
Battery Sensor Recalibration Procedure
If disconnecting the negative (-) battery cable from the battery during
repair work for the vehicle equipped with Alternator Managing Syst ...
Brake Booster Vacuum Pressure Sensor: Description
In order to ensure adequate brake power assistance in every situation,
the brake booster is equipped with a partial vacuum sensor. The brake booster
vacuum pressure sensor is located beside t ...
TPMS Receiver Description
TPMS Receiver Replacement