Kia Rio: A/C Pressure Transducer Replacement - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: A/C Pressure Transducer Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).


4.
Remove the A/C pressure transducer (A).

Tightening torque:
10~12 N.m (1.02~1.22 kgf.m, 7.4~8.8 lb-ft)



     
Take care that liquid & suction pipe are not bent.
5.
Install in the reverse order of removal.



     
When installing, replace with new O-ring (A).
A/C Pressure Transducer Inspection
1. Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”. 2. Inspect the volt ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling. ...

See also:

Operation Principle
   • In the ISG mode, if the power of an audio system turns OFF by drawdown while “ ...

TPMS Sensor Removal
   Handle the sensor with care. 1. Remove the tire. (Refer to "Tire Removal") ...

Valve Body Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

Copyright www.kirmanual.com 2014-2026