Kia Rio Manuals

Kia Rio: Removal - Engine Control Module (ECM) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal


     
When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used ECM]
1.
Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)
2.
Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
-
Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ECM Connector (A).
3.
Remove the battery (Refer to "Charging System" in EM group).
4.
Remove the mounting bolts and nut, and then remove the ECM bracket assembly (A).
Circuit Diagram
(M/T) (A/T) ...

Installation
   When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

See also:

Description
Due to the considerably more frequent occurrence of starting operations, the electrical load that occurs often leads to voltage dips in the vehicle network. In order to stabilize the power s ...

Circuit Diagram
Hamess Connector Pin No. Discription Remark 1 - 2 - 3 - 4 ...

Refrigerant System Service Basics
Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a (R-134a) from the air conditioning system. ...

Categories

Copyright www.kirmanual.com 2014-2026