Kia Rio: Removal
|
| 1. |
Disconnect the ignition lock switch connector (A) and clutch switch
(B).
|
| 2. |
Disconnect the push rod (B) from the clutch pedal by removing
the snap pin (A) and washer.
|
| 3. |
Remove the clutch pedal mounting nuts (A-4ea).
|
| 4. |
Remove the clutch pedal assembly.
|
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floorboard) and the clutch pedal clevis pin play (measured at
the ...
Installation
1.
Installation is in reverse order of removal.
...
See also:
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
2.
Remove the front bumper cover. (Refer to t ...
Rear Wheel Speed Sensor Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...
Rear Wheel Speed Sensor Removal
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025