Kia Rio Manuals

Kia Rio: Rear Shock Absorber Replacement - Rear Suspension System - Suspension System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rear Shock Absorber Replacement

1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

     
Be careful not to damage to the hub bolts when removing the rear wheel & tire.


2.
Loosen the bolt & nut and then remove the rear shock absorber (A) from the torsion beam axle (B).
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)


3.
Remove the rear shock absorber (A) from the frame by loosening the bolt.
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)


4.
Installation is the reverse of removal.
Rear Shock Absorber Components
   • Must completely be tigtened at the curb position of vehicle when assemble shock ...

Rear Shock Absorber Inspection
1. Check the components for damage or deformation. 2. Compress and extend the piston and check that there is no abnormal resistance or unus ...

See also:

Trunk
Opening the trunk With the trunk lid release lever To open the trunk from inside the vehicle, pull up the trunk lid release lever. The trunk will automatically lock when the trunk lid closes. & ...

Installation
1. Dowel pin of crankshaft setted about 3° with vertical center line. 2. Align the TDC marks (A) of the CVVT sprockets with the upper s ...

Power Out Side Mirror Switch Inspection
1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") ...

Categories

Copyright www.kirmanual.com 2014-2026