Kia Rio Manuals

Kia Rio: Rear Wheel Speed Sensor Removal - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rear Wheel Speed Sensor Removal

1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)


3.
Remove the rear seat back.
(Refer to the Body group - "Seat")
4.
Remove the rear wheel housing trim.
(Refer to the Body group – "Interior trim")
5.
Disconnect the rear wheel speed sensor connector.
6.
Installation is the reverse of removal.
Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor connector 2. Rear wheel speed sensor ...

Rear Wheel Speed Sensor Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground.    ...

See also:

AVN Head Unit Removal
AVN Head Unit    • Take care not to scratch the center fascia panel and related parts ...

Engine compartment
1. Engine Coolant Reservoir 2. Engine Oil Filler Cap 3. Brake/Clutch Fluid Reservoir 4. Air Cleaner 5. Fuse Box 6. Negative Battery Terminal 7. Positive Battery Terminal 8. Radiator Cap 9. E ...

Temperature Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the driver side shower duct (A) after loosening the screw. ...

Categories

Copyright www.kirmanual.com 2014-2026