Kia Rio: BCM (Body Control Module)

Transmitter Code Registration (Using GDS)

1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Specifications

Item Requirement Remark Rated voltage DC 12V Shall activate normally in these range. Operating voltage range DC 9 ~ 16V ...

See also:

Seat Heater Switch Removal
1. Disconnect the battery (-) terminal. 2. Remove the console assembly. (Refer to the BD group - "Console") ...

Rear Washer Switch Inspection
1. With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace t ...

Circuit Diagram
...