Kia Rio: Rear Washer Switch Inspection - Rear Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Rear Washer Switch Inspection

1.
With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.


Rear Wiper Switch


Rear Washer Switch


Rear Wiper Motor Inspection
Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals ...

Rear Washer Motor Inspection
1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. 2. Remove the front bumper cover. (Refer to t ...

See also:

Relay Box (Engine Compartment) Inspection
Replacement of EMS box 1. Disconnect the negative (-) battery terminal. 2. Push hooks in the engine room relay box out to the arrow directio ...

SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12)  Internal resistance(&# ...

Blower Unit Component Location
...

Copyright www.kirmanual.com 2014-2026