Kia Rio: Brake Switch Inspection
| 1. |
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in and when it is released.
|
| 2. |
The stop lamp switch is in good condition if there is no continuity
when plunger (A) is pushed.
|
Brake Switch Description
The present brake switch is used as an input variable for the ISG function
to detect bracke operation.
...
Brake Switch Removal
1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel. (Refer to the Body group-"crash
pad")
3.
...
See also:
Components Location
1. Purge control solenoid valve (PCSV)
2. Vapor line
3. ORVR valve
4. Fuel tank air filter
5. Canister close valve (CCV)
6. Canister
7. Fuel tank pressure sensor ( ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Circuit Diagram
...
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2025 Owners Manual
- Kia Rio YB 2017-2025 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2025