Kia Rio: Back-up Lamp Switch Inspection

1.	Disconnect the back up lamp switch connector (A).

2.	Check the continuity between no. 1 and 2 terminals of backup lamp switch. When the shift lever is in reverse, there should be continuity.

3.	If necessary, repair or replace the backup lamp switch.

Back-up Lamp Switch Specifications

1. Working voltage: DC 10~15V 2. Operating force: 3.0kg Max. 3. Voltage drop: - 0.4V 4. ...

Back-up Lamp Switch Replacement

1. Disconnect the back up lamp switch connector (A). 2. Remove the back up lamp switch (A). 3. ...

See also:

Heated Steering wheel System Circuit Diagram
Terminal Function Housing Pin Function Wire color Pad A GND Back B HEATER Yellow C ...

Ignition Coil: Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

Engine overheat
If your temperature gauge indicates overheating, you will experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1.Pull off the ...

Categories

Copyright © www.kirmanual.com 2014-2025