Kia Rio: SS-B Solenoid Valve(ON/OFF) Installation
|
1. |
Installation is the reverse of removal.
|
| •
|
When installing, apply the ATF oil or white vaseline to
the O-ring (A) not to be damaged.
|
| •
|
The gasket of the valve body gasket (A) use new one.
|
| •
|
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
|
|
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
Inhibitor Switch monitors the lever's position(PRND) and is used to control
gear setting signals.
...
See also:
Installation
•
Install the component with the specified torques.
•
...
Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation
of the input shaft inside the transaxle and delivers the readings to the TCM.
The sensor provides critical input data ...
Antenna Removal
1.
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
2.
Disconnect the antenna cable and the connector (A).
...
SS-B Solenoid Valve(ON/OFF) Removal
Inhibitor Switch Description