Kia Rio: TJ Joint Components - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2026 Service ManualKia Rio: TJ Joint Components

[LH]


1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Shaft
6. TJ boot band
7. TJ boot
8. Spider assembly
9. Snap ring
10. TJ case
11. Snap ring

[RH]


1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ case
13. Circlip

Front Driveshaft Inspection
1. Check the driveshaft boots for damage and deterioration. 2. Check the driveshaft spline for wear or damage. 3. ...

TJ Joint Replacement
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

See also:

Windshield Wiper-Washer Switch Removal
Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

Rain Sensor Inspection
Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the ...

Thermostat: Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting (A). ...

Copyright www.kirmanual.com 2014-2026