Kia Rio Manuals

Kia Rio: Seat Belt Buckle Switch (BS) Installation - SRSCM - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Seat Belt Buckle Switch (BS) Installation


     
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
4.
Install the front seat assembly.
(Refer to the Body group - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. ...

Weight Classification System (WCS) Description
WCS is intended to detect the occupant’s physique in order to determine whether the passenger airbag should be suppressed or deployed. WCS classifies the front passenger side seat by measur ...

See also:

Input Speed Sensor Specifications
▷ Type: Hall effect sensor Operation condition [°C(°F)] ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (1.2 ~ 1.8) 0.0472 ~ 0.0709 Output vol ...

Flat tire
Jack and tools The spare tire, jack, jack handle and wheel lug nut wrench are stored in the luggage compartment. Remove the luggage under tray out of the way to reach the equipment. (1) Jack ha ...

Rear Wheel Alignment
   When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always p ...

Categories

Copyright www.kirmanual.com 2014-2026