Kia Rio Manuals

Kia Rio: Transaxle Control Module (TCM) Replacement - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Transaxle Control Module (TCM) Replacement


     
When replacing the TCM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used TCM]
1.
Perform "TCM neutralization mode" procedure with GDS. (Refer to "Immobilizer" in BE group)
2.
Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]– Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the TCM connector (A).
3.
Remove the bracket installation bolts (A) and the nut (B).
TCM installation bolt/nut :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)



Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side c ...

Transaxle Control Module (TCM) Installation
1. Installation is reverse of removal.    In the case of the vehicle equipp ...

See also:

Components
1. Receiver 2. TPMS Sensor (S1) 3. TPMS Sensor (S4) 4. TPMS Sensor (S2) 5. TPMS Sensor (S3) 6. Tread Lamp ...

Power Mosfet (FATC) Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. ...

A/C Pressure Transducer Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/charging station. 3. ...

Categories

Copyright www.kirmanual.com 2014-2026