Kia Rio: Installation - DC DC Converter - Charging System - Engine Electrical System - Kia Rio UB 2012-2025 Service ManualKia Rio: Installation

1.
Install in the reverse order of removal.

     
After reconnecting the battery negative cable, ISG function dose not operates until the system is stabilized, about 4 hours.
If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with ISG function, Battery sensor recalibration procedure should be performed after finishing the repair work.
(Refer to Charging System - "Battery Sensor")
Removal
1. Disconnect the battery negative terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") ...

Battery
...

See also:

Components
...

Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side ...

Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is seen. Make this adjustment before you start driving. Do not place objects in the rear seat which would interfere with y ...

Copyright www.kirmanual.com 2014-2025