Kia Rio: Brake Switch Description

The present brake switch is used as an input variable for the ISG function to detect bracke operation.

Oil Pump Unit (OPU) Inspection

OPU Problem Inspection Procedure 1. TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector ...

Brake Switch Inspection

1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

See also:

In car sensor (FATC only) Description
The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the r ...

Temperature Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the driver side shower duct (A) after loosening the screw. ...

Failure Diagnosis
1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...