Kia Rio: Blower
- Blower Unit Component Location
- Blower Unit Components
- Blower Unit Replacement
- Blower Motor Inspection
- Blower Motor Replacement
- Blower Resistor (MANUAL) Inspection
- Blower Resistor (MANUAL) Replacement
- Power Mosfet (FATC) Inspection
- Power Mosfet (FATC) Replacement
- Climate Control Air Filtar Description
- Climate Control Air Filtar Replacement
- Intake Actuator Description
- Intake Actuator Inspection
- Intake Actuator Replacement
Foot Actuator (With Auto Defogging System) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to BD group - “Crash pad”)
...
See also:
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...
Antenna Installation
1.
Install the roof antenna, then connect the cable and the connector.
2.
Install the rear roof trim.
...
Rain Sensor Removal
The rain sensor may not operate properly if contaminated. Protect
the rain sensor surface by not removing the cover unti ...
Copyright © www.kirmanual.com 2014-2020