Kia Rio: ISG (Idle Stop & Go) System
- Description
- Operation
- Operation Condition for the ISG function
- Components Location
- Battery Sensor: Description
- Brake Booster Vacuum Pressure Sensor: Description
- Brake Booster Vacuum Pressure Sensor: Circuit Diagram
- Brake Booster Vacuum Pressure Sensor: Inspection
- AGM Battery: Description
- AGM Battery: Specification
- AGM Battery: Adjustment
- AGM Battery: Removal and Installation
- AGM Battery: Inspection
- AGM Battery: Cleaning
- DC/DC Converter: Component Location
- DC/DC Converter: Circuit Diagram
- DC/DC Converter: Removal and Installation
- ISG OFF Switch: Description
- ISG OFF Switch: Inspection
- Alternator: Description
- Alternator: Specification
- Alternator: On-vehicle Inpection
- Alternator: Removal and installation
- Starter: Description
- Starter: Removal and Installation
- Electric Oil Pump: Description
- Electric Oil Pump: Circuit Diagram
- Electric Oil Pump: Removal
- Electric Oil Pump: Installation
- Oil Pump Unit (OPU) Connector
- Oil Pump Unit (OPU) Circuit diagram
- Oil Pump Unit (OPU) Removal
- Oil Pump Unit (OPU) Installation
- Oil Pump Unit (OPU) Inspection
- Brake Switch Description
- Brake Switch Inspection
- Brake Switch Removal
- Brake Switch Installation
- Door Switch Description
- Door Switch Inspection
- Door Switch Removal
- Door Switch Installation
- Seat Belt Switch Description
- Seat Belt Switch Inspection
- Seat Belt Switch Removal
- Seat Belt Switch Installation
- Hood switch Description
- Hood switch Inspection
- Hood switch Removal
- Hood switch Installation
Installation
•
Install the component with the specified torques.
•
...
Description
Idle Stop & Go (ISG) function automatically switches off the engine when
the car is at a standstill if the and starts it again as soon as the brake pedal
is released. This not only reduce ...
See also:
System Circuit Diagram
MDPS Circuit Diagram
Harness Connector
Connector
Pin no
Pin name
Descrption
Specifcation
TAS sensor signal 8P connector A
1
...
Front Hub / Knuckle Disassembly
1.
Remove the snap ring (A).
2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the ...
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Copyright © www.kirmanual.com 2014-2020